Braun Infusomat Space Service Manual page 121

Measuring Time
6 min 36.0 sec
6 min 18.0 sec
6 min 14.4 sec
6 min 10.8 sec
6 min 7.2 sec
6 min 3.6 sec
6 min 0.0 sec
5 min 56.4 sec
5 min 52.8 sec
5 min 49.2 sec
5 min 45.6 sec
5 min 42.0 sec
5 min 24.0 sec
Table 6 - 2
EN Infusomat® Space 6.0
Delivery rate determination:
1. Set a delivery rate of 200 ml/h and let device fill up ≥60 s.
2. Hang the outlet cannula over the container and at the same
3. After the time has expired stop the stop watch and the Infu-
4. Determine the delivery rate immediately.
-
Drop Sensor (Option)
1. Connect the optional drop sensor to the device.
Deviation
%
2. Start infusion according to the specifications of the TSC.
-10
3. Squeeze the drop chamber bottom part to generate a jet. The
-5
4. Pull the drop sensor from the drop chamber. Only then start
-4
-3
-2
Air Inline Sensor
-1
1. Plug Space service connector onto connector "P2".
0
2. Insert an Infusomat® Space Line filled with water in the de-
1
2
3. In the
3
4
4. Read off value after approximately 10 seconds and compare
5
10
Note
If the water or air value is not reached immediately, these values
must be read again after 120 seconds.
5. Document values.
6. Read off the values of the temperature sensors on the LC dis-
7. Enter a delivery rate of 250 ml/h and a volume of 250 ml.
8. Start infusion.
Procedural Instructions on the TSC
time start the stop watch and the Infusomat® Space.
somat® Space.
Delivery volume to be expected:
at 12 min: 40 g ± 2 g (± 5%)
at 6 min: 20 g ± 1 g (± 5%)
drop sensor triggers an alarm immediately.
the device. Alarm by the drop sensor within 5 seconds.
vice and close operating unit.
Line change
menu, press the ">" button on the device
. The value of the air inline sensor is displayed on the LC dis-
play.
with the specifications of the TSC.
play and compare the difference with the specifications of
the TSC.
6
6 - 9