Braun IryPump S Step-By-Step Manual

IryPump S
®
Rectal Irrigation - Step by Step Guide
Turn on the IryPump S
®
to check if the battery is
properly charged.
Fill the water container
with the advised amount
of water. Temperature
between 36°C and 38°C.
Expel all air from the
tube by turning the
control wheel to level 3.
Ring is red = IryPump S
®
needs charging. Ring is
green = ok to begin
irrigation.
Attach the filled water
container back onto the
pump module.
Ensure that you are in
a comfortable position.
Lubricate the cone and
carefully insert it into the
anus.
Remove the water
container from the pump
module by pressing the
side release button.
Use the quick connector
to fasten the tubing
system onto the pump.
tip!
Use a water based
lubricant to lubricate
the cone.
Extend the water
container. Pull the inner
section up until it
audibly clicks into position.
Connect the other end of
the tubing system to the
cone.
Hold the cone in place by
applying a slight pressure
throughout the irrigation
procedure.