At-X9Em/Xt4 Card; Figure 17: At-X9Em/Xt4 Card; Table 14: Copper Cables For The At-X9Em/Xt4 Card - Allied Telesis AlliedWare Plus Installation Manual

AT-x9EM/XT4
Card
This card adds four additional networking ports to the switch, The ports
can operate at either 1Gbps or 10Gbps and have RJ-45 connectors for
copper cables. Refer to Figure 17.
Note
The card requires version 5.4.5-2 or later of the management
software. The instructions in "Displaying the Hardware Status and
AlliedWare Plus Version Number" on page 145 explain how to
determine the version number of the software on the switch.
The cable requirements for the ports are given in Table 14.
Table 14. Copper Cables for the AT-x9EM/XT4 Card
Port Speed
1Gbps
10Gbps
Each port has one LED. The states of the LED are defined in Table 15 on
page 56.
x930 Series Installation Guide for Virtual Chassis Stacking
Figure 17. AT-x9EM/XT4 Card
Cable Type
Standard TIA/EIA 568-A-
compliant Category 5 or
TIA/EIA 568-B-compliant
Enhanced Category 5 (Cat
5e) shielded or unshielded
cabling
Standard TIA/EIA-568-C.1
compliant Category 6a (Cat
6a) shielded or unshielded
cabling
Maximum
Operating Distance
100 m (328 ft)
100 m (328 ft)
55