Speed Control Operation - Mitsubishi Electric MELSERVO-J3 Series Instruction Manual

17. SPEED CONTROL OPERATION

(2) Indication list
Display Status
Waiting for CC-Link
b # #
communication
(Note 1)
d # # Ready
(Note 1)
C # #
Not ready
A
(Note 2)
* * Alarm/Warning
8 8 8
CPU error
(Note 3)
d 0 0.
C 0 0.
(Note 3)
(Note 1)
d # #. Test operation mode
C # #.
Note 1. ## denotes any of numerals 00 to 64 and what it means is listed below.
2. ** indicates the warning/alarm No.
3. MR Configurator or the MR-PRU03 parameter module is required.
・ The servo amplifier power was switched on when the CC-Link master module power was
off.
・ The CC-Link master module is faulty.
Indicates that initialization is completed, and the servo amplifier is in servo-on state and ready
to operate.
Indicates that the servo amplifier is being initialized or an alarm has occurred.
Indicates the alarm No./warning No. that occurred. (Refer to section 17.9.4.)
Indicates that a CPU watchdog error has occurred.
JOG operation, positioning operation, program operation, DO forced output.
Motor-less operation
## Description
00 Set to the test operation mode.
01 Station number 1
02 Station number 2
03 Station number 3
: :
: :
62 Station number 62
63 Station number 63
64 Station number 64
17 - 33
Description