Configuration Including Auxiliary Equipment - Mitsubishi Electric MELSERVO-J3 Series Instruction Manual

1. FUNCTIONS AND CONFIGURATION

1.7 Configuration including auxiliary equipment

(1) MR-J3-100T or less
(a) For 3-phase or 1-phase 200V to 230VAC
R S T
(Note 3)
Power supply
Molded-case circuit
breaker (MCCB)
Magnetic
contactor
(MC)
Line noise
filter
(FR-BSF01)
L
L
L
(Note 2)
Power factor
improving DC
reactor
(FR-BEL)
Note 1. The battery (option) is used for the absolute position detection system in the position control mode.
2. The power factor improving AC reactor can also be used. In this case, the power factor improving DC reactor cannot be used.
When not using power factor improving DC reactor, short P
3. 1-phase 200V to 230VAC power supply may be used with the servo amplifier of MR-J3-70T or less.
For 1-phase 200V to 230VAC, connect the power supply to L
specification.
POINT
Equipment other than the servo amplifier and servo motor are optional or
recommended products.
(Note 2)
1
2
3
P
1
P
2
P C
Regenerative option
Servo amplifier
U
V
W
and P .
1 2
L and leave L open. Refer to section 1.2 for the power supply
1 2 3
1 - 26
MR Configurator Personal
computer
CN5
CC-Link
CN3
CN1
CN6
CN2
CN4
(Note 1)
Battery
MR-J3BAT
Servo motor
I/O signal