Adding Confirmation Steps By Strengthening Security Of Ethernet Connection - Epson RC700 Series Maintenance Manual

5.5 Adding Confirmation Steps by Strengthening Security of EtherNet
Connection
From the following firmware version password authentication is required when connecting
Controllers and PCs to a global accessible network.
F/W : Ver.7.4.8.x
In the following cases, connections of EtherNet (PC) connector and Remote Ethernet are
not available.
When the Controller firmware is updated under the following conditions, additional steps to
confirm whether to continue the firmware update may be execute depending on the
configuration settings of the Controller. (step 3 or later shown below)
The following describes the steps to confirm whether to continue the firmware update.
(1) Insert "Firmware CD-ROM" to be installed into the CD-ROM driver of the
(2) Execute "CtrlSetup70.exe".
(3) Controller Setup window is displayed.
RC700 Series Maintenance Rev.3
Controller IP address is set to global IP address
Firmware version is 7.4.8.x or later
EPSON RC+7.0 is Ver.7.4.7 or before
Controller IP address is set to global IP address
Firmware version to be installed is 7.4.8.x or later
development PC.
Select the <Upgrade> button and click the <Next> button.
Maintenance 5. Firmware Update
23