Table of Contents
Advertisement
Configuration Examples
The following describes examples of configuration required to use software-link features or for
system operations.
Link with Management Software
To control power supply of the server with NEC ESMPRO Manager via the network
Select [System Hardware] → [AC-LINK] → [StayOff].
To use the management PC with "NEC MWA" installed for remote operations
Remote operation via LAN
Select [Advanced] → [Advanced] → [RomPilot Support] → [Enabled].
Remote operation via direct connection using cross cable
Select [System Hardware] → [Console Redirection] → [Console Connection] → [Direct].
Remote operation via WAN
Select [System Hardware] → [Console Redirection] → [Console Connection] →
[Via Modem].
UPS
To link power supply with the UPS
To power on the server when power is supplied from the UPS
Select [System Hardware] → [AC-LINK] → [Power On].
To keep the server off-powered even when power is supplied from the UPS if the POWER
switch was used to power off
Select [System Hardware] → [AC-LINK] → [Last State].
To keep the server off-powered even when power is supplied from the UPS
Select [System Hardware] → [AC-LINK] → [StayOff].
Keyboard
To set NumLock and key repeat
Select [Advanced] → [Keyboard Features] and set each item.
System Configuration
4-5
Advertisement
Table of Contents
