NEC Express 5800/320Lc User Manual page 154

4-22 System Configuration
The table below lists how selections for "AC LINK" determine the power status of the server when
the power supply to the server restarts.
State before powered off
In service
Out of service (DC power: Off)
Forced shutdown *
* Pressing the POWER switch for over four seconds shuts down the power to the server.
Thermal Sensor
Select "Thermal Sensor" on the System Hardware menu and press Enter to display the following
screen.
Thermal S ensor:
Upper Limit:
Lower Limit:
F1 Help
Esc Ex it
See the table below for setup options on the screen.
Option Parameter
Thermal [Enabled]
Sensor
Disabled
Upper Limit 7 - [48] - 80
Lower Limit 0 - [5] - 73
Stay Off
Phoenix BIOS Setup Utility
Thermal S ensor
[Enabled]
[48]
[5]
Select Item -/+ Change Values
Enter Select
Select M enu
Description
Enable or disable the thermal sensor
monitoring feature.
Specify the upper limit temperature for
boot-up restriction in Celsius. Use + and/or -
keys to specify a value by adding a number
greater than 7 to the value specified for
Lower Limit.
Specify the lower limit temperature for
boot-up restriction in Celsius. Do not specify
4 degrees or lower. Use + and/or - keys to
specify a value by deducting a number
greater than 7 to the value specified for
Upper Limit.
Parameter
Last State
Off On
Off Off
Off Off
System Hardware
Item Specific Help
Determines if BIOS will
disable boot, if the
temperature is not
within safe range.
F9 Setup Defaults
Sub-Menu F10 Save Changes & Exit
Power On
On
On
On
Your Setting
[ ]: Factory-set