NEC Express 5800/320Lc User Manual page 148

4-16 System Configuration
Option Parameter Description
POST Pause 1 - [3] - 20
Monitoring
Time-out
IMPORTANT:
When connecting a Fibre Channel disk array device, change the set value of "Boot
Monitoring Time-out Period" depending on the wait time for the completion of the Fibre
Channel disk array device initialization.
Ex.: If the wait time for the completion of the Fibre Channel disk array device initialization
is 4 minutes, change the value of "Boot Monitoring Time-out Period" from 10 (default) to
14 minutes.
If you set a small value for "Boot Monitoring Time-out Period", you can shorten the waiting
time to the rebooting. It is recommended to set a value of more than 3 minutes though smaller
value setting is available when external devices are not used. As it depends on the user's
setting environment, make sure to execute enough evaluation after the configuration of the
environment.
Option ROM
Select "Option ROM" on the Advanced menu to display the following screen and enable/disable
expansion of Option Rom BIOS on the PCI bus.
On Board SCSI:
On Board LAN 1:
On Board LAN 2:
PCI Slot 1:
PCI Slot 2:
PCI Slot 3:
F1 Help
Esc Ex t i
Specify the POST monitoring time period during
boot-up restriction.
Phoenix BIOS Setup Utility
Advanced
Option R OM
[Enable d]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
-/+
Select Item
Enter Select
Select M enu
Item Specific Help
Disables/enables the
mapping of the on-board
SCSI B
Change Values F9 Setup Defaults
Sub-Menu F10 Save Changes & Exit
Your Setting
[ ]: Factory-set
IOS .