Change Drive Letter - NEC Express 5800/320Lc User Manual

Nec server user's guide
Table of Contents

Advertisement

CHANGE DRIVE LETTER

To add, change or delete drive letters, follow the steps below. Before making any changes,
thoroughly read the NEC Express5800/ft series-specific precautions and general precautions for
Windows.
1.
Select [Start] - [Control Panel] - [Administrative Tools] and open [Computer Management].
2.
In the console tree of [Computer Management], click [Disk Management].
3.
Right-click a target partition, logical drive or volume and click [Change Drive Letter and
Paths...].
4.
Perform one of the following:
To assign a drive letter, click [Add...], a drive letter to use, then [OK].
To change a drive letter, click the drive letter to change, [Change...], a drive letter to use,
then [OK].
To delete a drive letter, click the drive letter to delete then [Remove].
IMPORTANT:
<NEC Express5800/ft series-specific precautions>
One CD-ROM drive for each PCI module (total of two CD-ROM drives) is installed in NEC
Express5800/ft series. If those CD-ROM drives' N-codes are different, the drive letter assigned to
the CD-ROM drive may be changed (reassigned) when the secondary PCI module becomes the
primary module at startup. In such case, follow the instruction above to change back the drive
letter. It is recommended to specify "D" as the CD-ROM drive's drive letter. (The change of drive
letter due to the change of primary PCI module can be suppressed.)
<General precautions for Windows>
Drive letter of system volume or boot volume cannot be changed.
Up to 26 drive letters can be used on a computer. "A" and "B" are drive letters for floppy disk
drives. Generally, hard disk drives are assigned "C" to "Z", but for network drives, drive
letters are assigned in a reverse order ("Z" to "C").
Because many of Windows programs refer to specific drive letters, cautions are required for
assigning drive letters. For example, the Path environment variable specifies a program name
and a specific drive letter.
For performing the procedure above, you need to be a member of Backup Operators group or
Administrators group, or you need to have appropriate authorization.
Windows Setup and Operation
3-39

Advertisement

Table of Contents
loading

Table of Contents