Replacing An Ffb Card - Sun Microsystems Ultra 1 Creator Series Service Manual

Caution – Avoid applying unequal force to one end or one side of the FFB card or
!
connector pin damage may occur.
7. Slowly lift the FFB card at an upward angle.
8. Lower the FFB card backplate.
9. Disengage the FFB card backplate from the back panel.
10. Place the FFB card on antistatic surface.
10.4.2

Replacing an FFB Card

Caution – Use proper ESD grounding techniques when handling components. Wear
!
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
1. Verify that both card retainers are pushed back (
FIGURE 10-18
2. Remove the replacement FFB card from its container.
Back panel tab (2)
Backplate
Replacing the FFB Card
Chapter 10
FIGURE 10-18
FFB card
System Board and Component Replacement
).
UPA socket
Card retainer (2)
10-21