Sun Microsystems Ultra 1 Creator Series Service Manual page 59

identifies the probe-scsi output message and
CODE EXAMPLE 4-4
identifies the probe-scsi-all output message.
probe-scsi Output Message
CODE EXAMPLE 4-4
ok probe-scsi
This command may hang the system
if a Stop-A or halt command has
been executed. Please type reset-
all to reset the system before
executing this command.
Do you wish to continue? (y/n)
ok probe-scsi
This command may hang the system
if a Stop-A or halt command has
been executed. Please type reset-
all to reset the system before
executing this command.
Do you wish to continue? (y/n)
Target 0
Unit 0 Disk
Target 1
Unit 0 Disk
Target 6
Unit 0 Removable Read Only
device
Enter n
Enter reset-all
Verify display blanks for
approximately 5 seconds and
returns to the ok prompt.
Enter y
SEAGATE ST32550W
Sun2.1G041200000000
Copyright (c) 1995 Seagate
All rights reserved ASA2
SEAGATE ST32550W
Sun2.1G041200000000
Copyright (c) 1995 Seagate
All rights reserved ASA2
TOSHIBA XM-
5301TASUN4XCD173506/22/95
Chapter 4 Troubleshooting Procedures
CODE EXAMPLE 4-5
4-11