Figure 10-13 Removing An Sbus Card From Slot 0 Or - Sun Microsystems Ultra 1 Creator Series Service Manual

3. Remove the unit cover.
See Section 7.1 "Removing the Cover" on page 7-1.
Caution – Use proper ESD grounding techniques when handling components. Wear
!
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
4. Attach the wrist strap.
See Section 7.2 "Attaching the Wrist Strap" on page 7-2.
5. Unlock the card retainers at the back edge of the SBus card by pushing the card
retainers back from the edge of the SBus card (
6. Grasp the SBus card at each corner and pull upwards slowly until the connector is
out of the slot.
Removing an SBus Card from Slot 0 or 1
FIGURE 10-13
Card retainer (2)
Chapter 10 System Board and Component Replacement
).
FIGURE 10-13
SBus slot 1
SBus slot 0
10-15