Diag-Level Nvram Variable Set To Min - Sun Microsystems Ultra 1 Creator Series Service Manual

CODE EXAMPLE 3-1
0> FAS366 Registers Test
0> ESP FAS366 DVMA burst mode read/write Test
0> FEPS Internal Loopbacks Test
0> Ethernet Transceiver Internal Loopbacks Test
0>CPU Functional Test
0> Mapping Selftest Enabling MMUs
0> SPARC Atomic Instructions Test
0> CPU Dispatch Control Register Test
0> CPU Softint Registers and Interrupts Test
0> CPU Tick and Tick Compare Registers Test
0> Uni-Processor Cache Coherence Test
0> UltraSPARC-2 Prefetch Instructions Test
0> *UltraSparc-1 module detected, tests skipped
0>Cross Calls Test (Dual CPU configuration only)
0> Cross Calls Test
0>Cache Coherency Test
0> Multi-Processor Cache Coherence Test
0>
<< POST COMPLETE(0) >>
3.4.2

Diag-level NVRAM Variable Set to Min

When the diag-level NVRAM parameter is set to min, POST enables an
abbreviated set of diagnostic-level tests. This mode requires approximately 30
seconds to complete.
the diag-level NVRAM variable set to min.
Diag-level NVRAM Variable Set to Max (Continued)
CODE EXAMPLE 3-2
identifies a serial port A POST output with
Chapter 3 Power-On Self-Test 3-9