Cd-Rom Drive Or 4-Mm/8-Mm Tape Drive; Removing A Cd-Rom Drive Or 4-Mm/8-Mm Tape Drive - Sun Microsystems Ultra 1 Creator Series Service Manual

9.3 CD-ROM Drive or 4-mm/8-mm Tape
Drive
To remove and replace the CD-ROM drive or the 4-mm/8-mm tape drive, proceed as
follows.
9.3.1 Removing a CD-ROM Drive or 4-mm/8-mm Tape
Drive
1. Power-off the system.
See Section 6.2 "Powering Off the System" on page 6-2.
2. Remove the system unit cover.
See Section 7.1 "Removing the Cover" on page 7-1.
Caution – Use proper ESD grounding techniques when handling components. Wear
!
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
3. Attach the wrist strap.
See Section 7.2 "Attaching the Wrist Strap" on page 7-2.
4. Remove the chassis bracket.
See Section 9.2.1 "Removing the Chassis Bracket" on page 9-5.
5. Remove the CD-ROM drive as follows (
a. Position the chassis bracket on top of a flat, antistatic surface, so that the CD-
ROM drive or 4-mm/8-mm tape drive is flat.
b. Remove the four screws securing the CD-ROM drive or 4-mm/8-mm tape drive
to the chassis bracket.
6. Remove the CD-ROM drive or 4-mm/8-mm tape drive.
7. Place the CD-ROM drive or 4-mm/8-mm tape drive aside on an antistatic surface.
9-10 Ultra 1 Creator Series Service Manual • August 1996
):
FIGURE 9-9