Sun Microsystems Ultra 1 Creator Series Service Manual page 11

Connecting Cables to the CD-ROM Drive, 4-mm/8-mm Tape Drive, and Diskette Drive 9-8
FIGURE 9-7
Positioning the Chassis Bracket 9-9
FIGURE 9-8
Positioning the CD-ROM Drive or 4-mm/8-mm Tape Drive 9-11
FIGURE 9-9
Positioning the Diskette Drive 9-13
FIGURE 9-10
Positioning the Diskette Drive 9-14
FIGURE 9-11
DC Power Disconnection 10-3
FIGURE 10-1
Captive Screws on the Back Panel 10-4
FIGURE 10-2
Sliding the System Board Out of the Chassis 10-4
FIGURE 10-3
Removing SBus Filler Panels from the Back Panel 10-5
FIGURE 10-4
Card Guide Exploded view 10-6
FIGURE 10-5
Installing the Card Guide 10-7
FIGURE 10-6
Sliding the System Board Into The Chassis 10-8
FIGURE 10-7
DC Power Connection 10-9
FIGURE 10-8
Location of the Serial Port Jumpers 10-11
FIGURE 10-9
Identifying Jumper Pins 10-12
FIGURE 10-10
NVRAM/TOD 10-13
FIGURE 10-11
SBus Slot Locations. 10-14
FIGURE 10-12
Removing an SBus Card from Slot 0 or 1 10-15
FIGURE 10-13
Removing the SBus Card Extractor 10-17
FIGURE 10-14
Replacing the SBus Card 10-18
FIGURE 10-15
Preparing to Remove the FFB Card 10-20
FIGURE 10-16
Removing the FFB Card 10-20
FIGURE 10-17
Replacing the FFB Card 10-21
FIGURE 10-18
Seating an FFB Card Into the UPA Socket 10-22
FIGURE 10-19
Securing the FFB Card Into the Chassis 10-23
FIGURE 10-20
DSIMM Ejection Lever 10-25
FIGURE 10-21
Removing a DSIMM 10-26
FIGURE 10-22
Installing a DSIMM 10-28
FIGURE 10-23
Figures xi