Figure 9-3 Replacing The Disk Drive - Sun Microsystems Ultra 1 Creator Series Service Manual

FIGURE 9-3
3. Replace the EMI door as follows (
Note – The EMI door must be flush with the chassis or the top cover will not fit
correctly.
a. Position the EMI door on the chassis; the two tabs should be hooked into the
two slots.
b. Push the EMI door in until it is flush with the chassis.
4. Detach the wrist strap.
5. Replace the system unit cover.
See Section 7.3 "Replacing the Cover" on page 7-3.
6. Power-on the system.
See Section 6.1 "Powering On the System" on page 6-1.
9-4 Ultra 1 Creator Series Service Manual • August 1996
Chassis
Disk drive
Drive handle
Replacing the Disk Drive
):
FIGURE 9-4
Drive handle