Figure 10-24 System Board Fan Plastic Cover - Sun Microsystems Ultra 1 Creator Series Service Manual

Caution – Use proper ESD grounding techniques when handling components. Wear
!
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
3. Attach the wrist strap.
See Section 7.2 "Attaching the Wrist Strap" on page 7-2.
4. Remove the two screws securing the system board fan and heatsink cover to the
system board (
5. Lift the plastic cover and pull the plastic cover up to remove it from the system
board.
System board fan
System Board Fan Plastic Cover
FIGURE 10-24
6. Disconnect the board fan connector from the system board at J0101 (
7. Remove the system board fan from the system board.
).
FIGURE 10-24
Screw (2)
Chapter 10
Plastic cover
System Board and Component Replacement
).
FIGURE 10-25
10-29