Figure 4-26 Installing the Drive
3.
Open the release lever, and insert the drive module into the drive bay.
4.
Close the release lever to lock the drive module in place.
Verify that the activity status LED on the drive tray is green after powering on the
server.
4.4.10 Hot-Swap PSU Replacement
To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching.
To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To remove the PSU:
1.
Grasp the handle, and press the blue release tab to release the PSU.
45