Hot-Plug Hdd Option - Inspur TS860M5 User Manual

5. Remove the dummy memory module.
6. Install the DIMM:
Step 1: Open the lock tabs on both ends of the DIMM slot.
Step 2: Align the bottom key with the receptive point on the slot, press both ends of the
DIMM with your thumbs. Insert the DIMM into the slot completely, and the lock tabs will
automatically secure the DIMM, locking it into place.

6.4 Hot-plug HDD Option

CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components,
minimize the amount of time the access panel is open.
1. Determine the status of the hard disk drive from the hot-plug HDD LED.
2. Back up all server data on the hard disk drive.
3. Remove the hard disk drive.
Step 1: Press the HDD panel button, the lever on HDD tray pops up automatically.
Step 2: Remove the HDD tray.
Step 3: Pull out the release levers to disengage them from the HDD location holes.
Hardware Options Installation
27