Firmware Update And Configuration; Cabling - Inspur NF5280M6 User Manual

Figure 4-36 Removing E1.S
To install E1.S:
1.
Align and install the four screws securing the E1.S onto the drive tray.
2.
Open the release lever, and insert the drive module into the drive bay.
3.
Close the release lever to lock the drive module in place.

4.5 Firmware Update and Configuration

For firmware update and configuration, refer to:
•
BMC Update Manual
•
BMC Configuration Manual
•
BMC User Manual
•
BIOS Update Manual
•
BIOS User Manual

4.6 Cabling

Blue indicates the data cable routing between the backplane and SAS/RAID card;
Red indicates the drive power cable routing between the backplane and the
motherboard.
•
To prevent damage to electrical components, properly ground the server
51