Onboard M.2 Drive Replacement - Inspur NF5280M6 User Manual

1. Remove the access panel (Refer to
2. Hold and press the release tab on one side of the fan module, and lift up the
fan module slowly out of the fan bay.
3. Put the fan module into an antistatic bag.
Figure 4-6 Removing the Fan Module
To install the fan module:
1. Take the new fan module out from the antistatic bag.
2. Align the fan power connector with the power connector on the motherboard,
and install the fan module vertically to the motherboard.
Figure 4-7 Installing the Fan Module
3. Install the access panel.
Verify that the fan status LED is off after powering on the server.

4.4.5 Onboard M.2 Drive Replacement

To remove the M.2 drive:
Access Panel Replacement).
30