Processor And Heatsink Module (Phm) Replacement - Inspur NF5280M6 User Manual

4.4.7 Processor and Heatsink Module (PHM)
Replacement
The server supports single- or dual-processor configuration depending on the model
you purchased.
•
To help avoid damage to the processor and motherboard, do not install the
processor without using the processor installation tool.
•
To prevent possible server malfunction and damage to the equipment,
multiprocessor configurations must contain processors with the same part
number.
To remove the PHM:
The heatsink may be hot after the system has been powered down. Allow the
heatsink to cool down for a few minutes before removing it.
1. Remove the access panel (Refer to
2. Disconnect the cable of the super-capacitor.
3. Remove the air duct (Refer to
4. Use a T30 Torx Screwdriver to loosen the four screws securing the Processor
Heatsink Module (PHM) to the CPU socket anticlockwise in the sequence as
shown on the heatsink label.
5. Press the lock-in wires inward with both hands to open positions.
6. Gently remove the PHM module from the CPU socket.
Access Panel Replacement).
Air Duct Replacement).
36