WAGO 750 XTR Manual page 59

WAGO I/O System 750 XTR
⇨ The parameterization dialog appears..
750-471/040-000 4AI U/I Diff Galv XTR
The WAGO-I/O-CHECK software from WAGO Kontakttechnik GmbH & Co. KG
can be used to conveniently and completely configure and parameterize the I/O
module, including:
• Graphical representation of the bus node
• Display of the measured values
• Settings for the application
• Configuration of the I/O module operating modes
• Parameterization of module, channel and scaling settings
• Calibration of channels and adjustment of analog inputs
• Monitoring
You can obtain the WAGO-I/O-CHECK software on a CD under Item No.
759-302. This CD contains all the application program files and an explanation.
You can find a description at the internet page at http://www.wago.com!
Save all your settings before you begin parameterization!
To be on the safe side you should always save all of your current settings in a
parameter file before you begin parameterization. This enables you to always
use the original values, should any parameters you are defining not be correct!
Behavior after Overwriting with WAGO-I/O-CHECK !
If WAGO-I/O-CHECK is used to overwrite a parameterization made with the
GSD file, the I/O module operates with the WAGO-I/O-CHECK settings until
the 750-333 Fieldbus Coupler is restarted. After restart, the I/O module is re-
parameterized via PROFIBUS using the GSD settings.
Commissioning 59
Manual
Version 1.0.2