Cummins Engine Parameters - Labrie AUTOMIZER FULL EJECT Maintenance Manual

To tap into the TCM, Labrie uses the following wires on the Allison connector:
Table 7 Input
Wire #
117 Pump pack enable
143 P
TO
142 Auto-neutral pack input
Table 8 Output
Wire #
130 PTO enable output
145 Neutral signal output

Cummins Engine Parameters

The following table contains the engine programming parameters specific to the A
E units. Enter those parameters into Cummins engine ECUs. For more information, call
JECT
LabriePlus.
Table 9 Cummins engine parameters
Menu: Features &
Parameters
Adjustable low idle
speed
Switched maximum
engine operating speed
Description
Active when the brakes are used, and when the PTO and
auto-neutral switches are ON (ground signal).
enable Active when the PTO switch is ON (+12­V signal).
Active when the brakes are used, and when the PTO and
auto-neutral switches are ON (ground signal).
Description
Active when the PTO switch is ON and when all engine
and vehicle speed criteria are respected (+12­V signal).
See Programmed Parameters on page 220.
Active when the transmission is in neutral. This signal
(ground signal) is used to allow fast idle engagement. For
more details, refer to the electrical schematic provided
with the vehicle.
Low idle speed adjustment switch
---------------------------------------------------------------
Low idle speed
Switched maximum engine operating speed
---------------------------------------------------------------
Maximum operating speed switch setup
---------------------------------------------------------------
Maximum switched engine speed
State
State
Parameter Name
Multiplexing 221
™ F
UTOMIZER ULL
Value
Disable
--------------------
700 rpm
Enable
--------------------
Active closed
--------------------
900 rpm