Necessary Materials - Mitsubishi Electric PURY-M200YNW-A1 Service Handbook

[9-1 Service Overview ]
(2) Control board on the HBC
SWP1
Push switch
(Function setting)
SWP3
Push switch
(Function setting)
SW002-9
9-1-3

Necessary Materials

The use of the USB function requires a USB memory stick and a portable battery charger.
See below for the types of USB memory stick and portable charger that can be used.
(1) USB memory stick
Use a USB memory stick that meets the following specifications.
USB 2.0 compatible
Formatted in FAT 32
Without a security function
(2) Portable battery charger
Use a portable battery charger that meets the following specifications for rewriting the software.
USB 2.0 compatible
Voltage and amperage rating of 5 V and 2.1 A (MAX)
Supports the energy-saving mode
A battery charger not compatible with the energy-saving mode may turn off while the data are being collected or while the
S/W is being re-written, and these actions may not be completed successfully.
A LEAD WIRE ASSY USB is required to connect the control board and the portable charger.
Use a cable that meets the following specifications.
[Type A male] - [Male XA connector for the PCB] USB cable. For details of "LEAD WIRE ASSY USB", please contact the
sales office.
The connector on the control board side is a female XA connector for the PCB.
BS_09_F
CN703
LD001
Service LED
chapter 9 -
3