Mitsubishi Electric PURY-M200YNW-A1 Service Handbook page 388

[8-13 Parts Replacement Instructions (Outdoor Unit) ]
(16) To remove the front heat exchanger, unscrew the screws on the front of the right front pillar. (4 screws on a standard
model or 3 screws on a high-efficiency model) (See Figure 17.)
To remove the left rear heat exchanger, unscrew the screws on the left side of the left front pillar and the screws on the
front of the center pillar (7 screws on a standard model or 8 screws on a high-efficiency model.) (See Figures 18 and 19.)
To remove the right rear heat exchanger, unscrew the screws on the right side of the right front pillar and the screws on
the front of the center pillar (7 screws on a standard model or 6 screws on a high-efficiency model.) (See Figures 19 and
20.)
Left front pillar
Connection of the pillar to
the left rear heat exchanger
(4 screws on a standard
model or 5 screws on a
high-efficiency model)
Unscrew
the screws.
Removing the left rear heat
exchanger (Figure 18)
BS_08_L
Front heat exchanger
Removing the front heat exchanger
(Figure 17)
Left rear
heat
exchanger
Removing the right and left rear heat
exchangers (Figure 19)
Connection of the pillar to the front heat exchanger
(4 screws on a standard model or 3 screws on a
high-efficiency model)
Unscrew the screws.
Right front pillar
Right rear
heat
Center pillar
exchanger
(3 screws)
Unscrew
the
screws.
Removing the right rear heat
exchanger (Figure 20)
Connection of the pillar to the right
rear heat exchanger (4 screws on
a standard model or 3 screws on a
high-efficiency model)
Unscrew the screws.
121
chapter 8 -