Mitsubishi Electric PURY-M200YNW-A1 Service Handbook page 438

[8-15 Main-HBC Maintenance Instructions ]
Operation procedures
31) Remove the nut by holding a spanner
between the back of the plate heat ex-
changer and the side panel.
(One nut in the front)
32) Unscrew the screws from the plate heat
exchanger fixing plate. (x3)
33) Remove the Victaulic joint.
See step 18 for how to remove the joint.
34) Remove the nut from the sheet metal
on the plate heat exchanger pipe side,
and remove the sheet metal.
35) As with the Cooling-main side, slide the
plate heat exchanger forward so that the
pipe on the plate heat exchanger and
the pump port do not overlap.
Then, remove the braze and pull out the
pipe.
BS_08_L
Illustrations
Victaulic joint
Nut
Sheet metal
Operation
location
Installation
location
Remove the nut (x1).
Pull out this pipe.
chapter 8 -
171