Mitsubishi Electric PURY-M200YNW-A1 Service Handbook page 383

[8-13 Parts Replacement Instructions (Outdoor Unit) ]
(20) To remove the front heat exchanger, loosen the screws on the right side of the right rear pillar. (4 screws on a standard
model or 3 screws on a high-efficiency model) (See Figure 17.)
To remove the rear heat exchanger, loosen the screws on the back of the right rear pillar. (4 screws on a standard model
or 3 screws on a high-efficiency model) (See Figure 18.)
Remove the screw holding the pillar to the rear heat exchanger support.
Connection of the pillar to the
front heat exchanger (4 screws on
a standard model or 3 screws on
a high-efficiency model)
Removing the front heat exchanger
(Figure 17)
(21) Remove the heat exchanger by diagonally lifting it up, using caution not to damage the fins or the pipes.
Removing the front heat exchanger
(Figure 19)
116
- chapter 8
Connection of the pillar to the rear
heat exchanger (4 screws on a
standard model or 3 screws on a
high-efficiency model)
Loosen the screws.
Removing the rear heat exchanger
Removing the rear heat exchanger
(Figure 20)
(Figure 18)
Loosen the screws.
Unscrew the screws.
BS_08_L