Mitsubishi Electric PURY-M200YNW-A1 Service Handbook page 355

[8-13 Parts Replacement Instructions (Outdoor Unit) ]
(12) Remove the braze at the three areas circled in Figure 12 to remove LEV2a and 2b assembly. (See Figure 12.)
LEV2a
Remove the
braze here.
(13) There are two types (A and B) of gas-liquid separators that connect to the check valve block as shown below.
The removal procedure depends on the type of gas-liquid separator. Follow the appropriate procedure that corresponds to
the gas-liquid separator type.
Removal procedures for gas-liquid separators A and B are explained separately below.
Gas-liquid separator A
Figure 13-1
88
- chapter 8
LEV2b
Figure 12
Gas-liquid
separator A
LEV2a
LEV2b
Remove the
braze here.
LEV2a and LEV2b assemblies
Gas-liquid separator B
Figure 13-2
Remove the
braze here.
Gas-liquid
separator B
BS_08_L