Mitsubishi Electric PURY-M200YNW-A1 Service Handbook page 403

[8-14 HBC Maintenance Instructions (Applicable to main and sub HBCs) ]
«To reconnect the wires»
Reconnect the wires by referring to the figures below.
Valve block and its surrounding components
Fix in place with cable ties.
<Thermistor wire>
<Motor wire>
put through one clip and two edge saddles.
Below the control box (left)
Fix in place with cable ties.
<Three-way valve wire>
<LEV1 wire>
<Thermistor 11, 15, 35 wires>
<Pressure sensor PW3 wire>
Clamp down in
two places.
<Power-supply wire>
Fix in place with cable ties.
<SV1 coil wire>
<Pump 1, 2 wires>
136
- chapter 8
<Thermistor wire>
Clamp down.
<Power-supply wire>
Clamp down, and
<21s4, SV1 coil wires>
Fix in place with cable ties.
<Thermistor 15, 35 wires>
Clamp down. Clamp down.
<M-NET wire>
Inside the control box
Clamp down
<21s4, SV1 coil wires>
Below the control box (right)
Fix in place with cable ties.
<Three-way valve wire>
<LEV1, 3 wires>
<Pressure sensor wire>
<Thermistor wire>
Clamp down.
<M-NET wire>
Clamp down.
<Three-way valve wire>
<LEV1, 2, 3 wires>
<Pressure sensor wire>
<Thermistor wire>
Clamp down.
<Motor wire of the block>
<Thermistor wire of the block>
Clamp down,
and put through
two edge saddles.
<M-NET wire>
Clamp down
<Motor wire of the block>
<Thermistor wire of the block>
BS_08_L