Mitsubishi Electric PURY-M200YNW-A1 Service Handbook page 302

[8-9 Troubleshooting Problems with Major Components on HBC ]
1) Check the self-diagnosis switch (Outdoor control board SW4 (SW6-10:OFF)).
Measurement data Symbol
Outdoor high pressure 63HS1
Outdoor low pressure 63LS
ON
1 2 3 4 5 6 7 8 9 10
2) Check the connector for P1 on the HBC control board for proper connections.
3) Check the pressure value on the self-diagnosis switch (same as note 2) with the connector of the applied pressure sensor is
disconnected from the board.
BS_08_L
SW4 setting value
ON
1 2 3 4 5 6 7 8 9 10
ON
1 2 3 4 5 6 7 8 9 10
The figure at left shows that the switches 1 through 5 are set to ON and 6 through 10 are set to OFF.
35
chapter 8 -