Mitsubishi Electric PURY-M200YNW-A1 Service Handbook page 368

[8-13 Parts Replacement Instructions (Outdoor Unit) ]
8-13-7 Maintenance Procedure for the Drain Pan
1. S-module
[Drain pan removal procedure]
(1) Remove the front panel from the unit by unscrewing the eight screws. (See Figure 1.)
(2) Cut the cable tie, unscrew the screw, and pull out the drain pan cover toward the right. (See Figure 3.)
(3) Remove the two rod holders holding the check joints in place, using a wrench. (See Figure 4.)
(4) Remove the drain pan by unscrewing the two screws. (See Figure 5.)
(5) Clean the drain pan and the drain pan cover. (See Figure 6.)
Remove dust and dirt from the drain groove.
Figure 1
Cable tie
Screw
Screw
Move the drain pan down by the
amount that the drain pan and the
fin guard are overlapped.
BS_08_L
Front panel
Pull out toward the right.
Figure 3
Pull the drain pan forward
and down.
Figure 5
Drain pan
Drain pan cover
Figure 2
Rod holders
Check joint
Figure 4
Screw
Figure 6
101
chapter 8 -