Table of Contents
Advertisement
a
b
c
d
a
b
c
6
Setting metering area
When Auto exposure mode is selected:
If the observation objects are scattered on the window, the full window
may be too bright or too dark due to the influence from the background
area excluding observation objects. This case may be improved by
changing the metering area.
Normally, 30% of the enter area of the image is the metering area.
1
Select the [Menu] tab a and select the [Camera Control] tab b in
the tab displayed.
2
Press the following buttons of [AE area] c to select the metering area.
Button
Full image
Full window
Spot 30%
Spot photometry 30% at the center of window
Spot 1%
Spot photometry 1% at the center of window
} Press [ON] button or [OFF] button of [Display AE area] d to
select Show or Hide metering area on the display. For selection
procedures, refer to "Setting AE area (P. 40)". When the [Display AE
area] is set to OFF, if the [Spot 30%] button or the [Spot 1%] button of
[AE area] is pressed, the metering area is displayed on the display
for 3 seconds and will be hidden.
} The metering area position cannot be changed.
7
Adjusting contrast
1
Select the [Controller] tab a .
2
If the setting items of Submenu are not displayed, press [Submenu]
b to open them.
3
Press the
button of [Contrast] c to select the contrast level in
the list.
Button
Normal
The image with the standard contrast can be
acquired.
Medium
The image with the medium contrast between
"Normal" and "High" contrast can be acquired.
High
The image with the high contrast can be acquired.
DP2-SAL
Function
Function
33
Advertisement
Table of Contents
