Table of Contents
Advertisement
a
a
d
b
c
2
Selecting exposure mode
b
1
If the setting items of Submenu on the [Controller] tab are not displayed,
Press [Submenu] a to open them.
2
Press the [AE] button b to select "Auto" or "Manual".
For procedures to set the exposure when "Manual" is selected, refer
to "Manual exposure acquisition (P. 35 )".
} The initial setting is "Auto" . From the next time, the system starts in
the mode selected when the power was turned OFF.
3
Exposure compensation
When Auto exposure mode is selected:
The exposure time specified by AE (Auto Exposure) can be
e
compensated. ("+ compensation" is available up to 1/6EV step
+ 1EV and "- compensation" is available up to 1/3EV step -2EV.)
When acquiring a dark specimen, perform "+ compensation" to make
the exposure time longer to bring the overexposed effect. When
acquiring a bright specimen, perform "- compensation" to make the
exposure time shorter to bring the underexposed effect.
1
Select the [Controller] tab a .
2
Press the
the bar c to set the exposure compensation values. The exposure
compensation value is displayed in d and the exposure time is in
e respectively.
or
button of [Exposure compensation] b or move
DP2-SAL
25
Advertisement
Table of Contents
