Table of Contents
Advertisement
3
Assembly
This section describes only the procedures to assemble the control box (D2-CB). For detailed descriptions of the
microscope, camera head and camera adapter, etc. to be used together, refer to the relevant instruction manual, and
assemble them with careful attention.
Be sure to turn OFF the main switch of the control box D2-CB during assembly.
CAUTION
a
e
16
1
b
2
b
a
c
CAMERA
d
Installing the control box D2-CB
} The control box D2-CB can be installed whether horizontally or
vertically.
} Do not place a heavy object weighing over 10 kg or an object that
would make the installation unstable on the control box D2-CB.
Horizontal installation
Place the rubber feet surface of the control box D2-CB on the table
surface.
Vertical installation
Attach the stabilizer a provided with the control box D2-CB on
the side of the control box D2-CB using the provided screws b .
Always use the provided stabilizer for vertical installation.
Connecting the interface cable
· Always use the interface cable (USB 3.0 cable) provided by
CAUTION
Olympus. Using commercially available USB 3.0 cables or
hubs does not guarantee the operations of the equipment.
· The interface cable is vulnerable to bend or twist.
· Connect the interface cable in the correct orientation
paying attention to the shape of the connector.
1
Connect the connector a of the interface cable to the connector b
of the camera head, and tighten the lock screw c (2 positions). Make
sure that the interface cable is secured completely.
Be sure to tighten the lock screws with your hand. If you
CAUTION
use the tool to tighten the lock screws too firmly, the screw
area of the connector of the camera head may be damaged.
2
Connect the connector d of the other end of the interface cable to
the Camera connector e of the control box D2-CB.
} If the interface cable is connected to the USB 2.0 connector, the
camera head does not work.
Advertisement
Table of Contents
