Recording Movie - Olympus DP2-SAL Instructions Manual

a
b
36
c
2

Recording Movie

1
Select the [Controller] tab a .
2
Operate the microscope to frame the position you want to record and
bring it into focus.
3
Press the [Movie] button b to start recording the movie. While
recording the movie,
displayed.
4
Press the [Movie] button b again to finish recording the movie. The
movies are saved in the recording media (HDD/SSD), etc.
} The movie can also be acquired by using "Shift+F8" of the keyboard.
} The movie size and the movie format while recording are described
below. They cannot be changed.
Movie size 960 x 720
Format Compressed AVI
} The folder names and file names of movies are created
automatically. For details, refer to "Folder names and file names (P.48)" .
TIP
The save destination of movies can be changed (P.46). However,
depending on the recording media's speed to write images or
the specified exposure time, the frame rate to record movies may
be reduced (as if movies are fast-forwarded) or frames may be
skipped.
Use the recording media (HDD/SSD) applicable to USB3.0
for acquiring movies. Also, adjust the light intensity so that the
exposure time is 1/30 s or less when DP27 is connected or 1/25
s or less when DP22 is connected.
} When acquiring the movie of specimens with fine structure, the bit
rate of the movie file may exceed the write speed of the recording
media and that may cause skipping of frames.
} While recording movies, the shading correction is OFF.
} While recording movies, only Show/Hide of control window can be
operated.
Change other settings after the recording is completed.
} The movie can be recorded for approximately 30 minutes.
However, while recording movies, if the movie file size reaches
the maximum or if there is no remaining capacity in the recording
media, the recording of the movie finishes automatically.
While recording movies, do not turn OFF the main switch
CAUTION
of the control box D2-CB.
blinks and the recording time c is
DP22 DP27
1224 x 960