Polycom RealPresence 1800 Getting Started Manual page 37

P R P C
OLYCOM EAL RESENCE OLLABORATION
Install the RealPresence Collaboration Server (RMX) 4000 as a Stand-
alone System
P R P C
OLYCOM EAL RESENCE OLLABORATION
S .8.6
ERVER V
3. Slide in the RTM ISDN card in the RealPresence Collaboration Server
slot.
A I
DDITIONAL NFORMATION
card in the opposite-facing front slot.
Figure 1-11: Install RTM ISDN Card on RealPresence Collaboration Server 2000
4. Push the card into the slot until the ejector levers touch the front edge
of the card cage.
5. Push the ejector levers to their fully closed position.
6. Tighten the captive screws on each side of the rear panel of the card,
securing the RTM ISDN card to the RealPresence Collaboration Server.
Instead of installing the RealPresence Collaboration Server (RMX) 4000 in a
rack, you can also put it on a flat surface, or desktop, as a standalone system.
T
ASK
1. To install the RealPresence Collaboration Server (RMX) 4000 as a stand-
alone system:
2. Place the RealPresence Collaboration Server (RMX) 4000 on a flat
surface or desktop.
A I
DDITIONAL NFORMATION
must rest on the four feet at the base of the MCU and must be shifted or
moved into position using the two handles attached to the front.
S G S
ERVER ETTING TARTED
I R P
NSTALLING THE EAL RESENCE
: An RTM ISDN card must connect directly to an MPMRx
: The RealPresence Collaboration Server (RMX) 4000
G
UIDE
A E I
PPLIANCE DITION NSTALLATION
C S (RMX) 4000
OLLABORATION ERVER
35