Polycom RealPresence 1800 Getting Started Manual page 28

A E I
PPLIANCE DITION NSTALLATION
I R P
NSTALLING THE EAL RESENCE
Connect the RealPresence Collaboration Server (RMX) 1800 to a Power
Source
Connect Cables to the RealPresence Collaboration Server (RMX) 1800
26
C S (RMX) 1800
OLLABORATION ERVER
The following restrictions apply to the conductors and connectors that may be
used to ground the unit when rack mounted:
• When using bare conductors, they must be coated with an appropriate
antioxidant compound before crimp connections are made. Tinned,
solder-plated or silver-plated connectors do not have to be prepared in
this manner.
• The same bolt assemblies should not secure multiple connectors.
• Listed fastening hardware must be compatible with the materials being
joined and must be preclude loosening, deterioration and electrochemical
corrosion of the hardware and joint materials.
T
ASK
1. To connect RealPresence Collaboration Server (RMX) 1800 to AC power:
2. Insert the power cable into the power connector on the rear panel of
the RealPresence Collaboration Server (RMX) 1800 system.
A I
DDITIONAL NFORMATION
• Do not connect the green or green-yellow wire to the system
single-point ground screw.
This section outlines the way to connect the cables to the RealPresence Collab-
oration Server (RMX) 1800.
T
ASK
1. To connect the cables to the RealPresence Collaboration Server (RMX)
1800:
2. Connect the management network cable to LAN 1 port.
A I
DDITIONAL NFORMATION
both the management and the media and signaling network connection.
3. Connect the media and signaling cable to LAN 2 port.
A I
DDITIONAL NFORMATION
LAN redundancy is enabled, LAN 2 is the backup of LAN 1 port.
P R
OLYCOM
: Use only the Polycom-supplied AC power cable
: When LAN redundancy is enabled, LAN 1 is used for
: By default this port is used for signaling, but when
P R P C
OLYCOM EAL RESENCE OLLABORATION
P C
EAL RESENCE OLLABORATION
S G S
ERVER ETTING TARTED
S .8.6
ERVER V
G
UIDE