Polycom RealPresence 1800 Getting Started Manual page 33

P R P C
OLYCOM EAL RESENCE OLLABORATION
Connecting Cables to the RealPresence Collaboration Server (RMX)
2000
P R P C
OLYCOM EAL RESENCE OLLABORATION
S .8.6
ERVER V
– Fasten the RealPresence Collaboration Server to the rack with
screws through the four holes in the RealPresence Collaboration
Server front mounting brackets.
Figure 1-9: Install the RealPresence Collaboration Server (RMX) 2000 on a shelf
Do not remove the protective caps from LAN1, LAN3 and ShMG ports when
you connect the cables to RMX 2000.
Connect the following cables to the back panel:
• Power cable.
• On the RTM IP card, connect the LAN cable to LAN 2.
A RealPresence Collaboration Server (RMX) 2000 always requires that an
RTM IP card be installed in the bottom slot on the rear of the RealPresence
Collaboration Server (RMX) 2000.
• RTM LAN card connections in MPMRx Card mode:
In MPMRx Card mode, an MPMRx card on the front of the RMX must
always be seated or connected opposite to either an RTM LAN-4 ports or
RTM ISDN card on the rear of the chassis. The RTM LAN-2 port card is
not supported with MPMRx card.
If the RTM LAN-4 ports card is selected to install with the MPMRx card.
Perform following steps to finish the LAN connections on the RTM LAN
card:
S G S
ERVER ETTING TARTED
I R P
NSTALLING THE EAL RESENCE
G
UIDE
A E I
PPLIANCE DITION NSTALLATION
C S (RMX) 2000
OLLABORATION ERVER
31