Date; Hose Replacement; Timer; Activation / Deactivation - ProMinent DULCO flex Control Operating Instructions Manual

'Menu'
Set up /

'Date'

12.2.9

'Hose replacement'

12.3
12.4

Timer

12.4.1

Activation / deactivation

60
'Menu / Information è Settings è Date è ...'
You can set the date in the
'Menu / Information è Service è Hose replacement è ...'
This menu only appears once a manual stop has been performed using
[STOP/START] .
Here you can replace a hose following the guidance provided. For the
detailed description - see Ä Chapter 15.1 'Replacing pump hose'
on page 86
'Menu / Information è Timer è ...'
Please first read this chapter to get an overview.
–
You will then understand the timer better when
working through the chapter.
The timer DULCO flex Control can do the following at predefined times
and intervals or event-dependent:
open / close the relays
n
switch the level of a Config I/O output
n
be triggered by the level at a Config I/O input
n
start a delayer
n
switch operating mode
n
allow the pump to work at a defined capacity
n
stop / start the pump
n
'Batch (time)' )
trigger a batch (
n
'Menu / Information è Timer è Activation è ...'
You can only program the timer when 'Activation' is set
to 'inactive' .
To program the timer, set
ð The first line of the timer menu
'Inactive' .
To activate the timer, set
ð The first line of the timer menu
'active' .
The timer starts working - the timer identifier
continuous display.
'Date' menu.
'Activation' to 'inactive' .
'Timer status' then shows
'Activation' to 'active' .
'Timer status' then displays
is visible in the