Table of Contents
Advertisement
12.4.1
Activation / deactivation
12.4.2
Setting the timer
allow the pump to work at a defined capacity
n
stop / start the pump
n
'Batch (time)' )
trigger a batch (
n
'Menu / Information è Timer è Activation è ...'
You can only program the timer when 'Activation' is set
to 'inactive' .
To program the timer, set
ð The first line of the timer menu
'Inactive' .
To activate the timer, set
ð The first line of the timer menu
'active' .
The timer starts working - the timer identifier
continuous display.
When 'Activation' is set to 'active' , the timer software
generates the state of the pump which the pump would
have precisely had at this time if it had been set to
'active' without any interruption.
Delayed, linked actions are unaffected by this.
'Menu / Information è Timer è Set timer è ...'
You can create commands (also known as "program lines") for a timer pro‐
gram in the
'Set timer' menu.
You can create up to 32 commands (program lines).
Create the command as follows:
'new' command (program line)
1 - Create a
'Triggering event' (trigger) and the time and/or interval if
2 - Select the
necessary
3 - Select
'Action' and a value, if necessary
4 - Check the command
5 - Create the next command – if necessary
Set up /
'Activation' to 'inactive' .
'Timer status' then shows
'Activation' to 'active' .
'Timer status' then displays
is visible in the
'Menu'
57
Advertisement
Table of Contents
