Settings For The "Diaphragm Break" Function (Diaphragm Break Menu); Settings In The "System" Menu" (System Menu); Service (Service Menu) - ProMinent Sigma/ 2 Control S2Cb Operating Instructions Manual

8.6.7 Settings for the "Diaphragm break" function (DIAPHRAGM BREAK menu)

Continuous

8.6.8 Settings in the "System" menu" (SYSTEM menu)

Main menu
Mode
Settings
Service
Information
Language
Continuous
display

8.7 Service (SERVICE menu)

l - Output current in mA
f - Stroke rate in strokes/min
L - Current litre output
L -
max
f - Maximum stroke rate in strokes/min
max
The current output emits a current of 20 mA above the value set here for
„Capacity at 20 mA" and above.
„Contact" and „Batch" operating modes, f is the stroke rate which is
In the
set in the "Stroke rate" continuous display.
Main menu
Mode
Settings
Service
Information
Language
display
Using the "Diaphragm break" programmable function, you can match the
behaviour under fault conditions of the pump to your requirements, pro‐
vided an electrical membrane rupture sensor is connected.
There is a choice, of whether a membrane rupture should lead to an
„Error" or a „Warning" . If „Inactive" is set, the pump does not react to a
diaphragm rupture, however the symbol dia indicates that an electrical
membrane rupture sensor is connected.
Settings
Calibrate
Dosing
Diaphragm break
System
End
„System" menu you can select whether the pump uses „Liter" or
In the
„Gallon (US)" as the „Unit" .
The following can be carried out from this menu:
„Clear counter"
1 -
2 - Set contrast (Menu
„HMI logout"
3 -
4 - Set safety settings for operating menu (
„ Capacity at 20 mA"
Settings
Dosing monitor
Relay
Diaphragm break
System
End
Analog output
Unit
End
„Display" )
Setting
Diaphragm break
Error
Warning
Inactive
Unit
Liter
Gallon (U.S.)
„Safety" menu)
59