Table of Contents
Advertisement
Supplementary instructions PROFIBUS
1
Supplementary instructions PROFIBUS
1.1 Requirements
Validity of the supplementary instruc‐
tions
1.2 Adjusting the controller
1.2.1 General
1.2.2 Configuring the PROFIBUS
4
®
DP
Personnel must be familiar with the contents of the "Assembly and
Operating Instructions for DULCOMETER
troller diaLog DACa".
The controller must have a PROFIBUS
These supplementary instructions are only valid when used in con‐
junction with the operating instructions for the multi-parameter con‐
troller diaLog DACb.
The controller with PROFIBUS
same way as the standard controller, with the addition of the bus
functionality.
Adjustment process cancelled
In the event of a pause longer than 60 s, the
adjustment process is cancelled.
®
DP
In order to control the controller using the PROFIBUS
must activate the PROFIBUS
(see the controller operating instructions).
While the PROFIBUS
DP is active, all external inputs will function.
®
The external inputs lead to the expected reactions as in the case of
the controller without PROFIBUS
operating instructions). The controller sends corresponding infor‐
mation over the PROFIBUS
Even if the fieldbus is set to inactive, the master is able to read-
access the controller data defined in its GSD file.
If the PROFIBUS
DP is inactive or set to inactive, the settings for
®
the operating mode selected prior to "inactive" status are reloaded
in the controller.
If the controller is switched to another operating mode, it stops and
can only be restarted using the
'Menu' : press the [Menu] key
1.
To access the
2.
Use the cursor keys to select the menu item
[OK] key
confirm with the
'Device setup' appears.
ð The menu
DP
®
®
Multi-parameter Con‐
®
DP module.
®
DP functionality is adjusted in the
®
DP in the controller operating menu
DP functionality (see controller
®
DP to the master (PLC, PC etc.).
®
[Stop/Start] key.
'Setup' and
®
DP, you
Advertisement
Table of Contents
