Hardware Specifications - Renesas QB-RL78I1A User Manual

QB-RL78I1A In-Circuit Emulator

1.1 Hardware Specifications

Target device
Operating voltage
Operating
frequency
Operating temperature range
Storage temperature range
External dimensions
Power
consumption
Weight
Host interface
Note1 Errors are within ±0.05%. However, this does not apply to errors of the oscillator or clock system
on the target board.
Note2 Errors are within ±0.005%. However, this does not apply to errors of the oscillator or clock
system on the target board.
Note3 When supplying 64MHz to the16-bit timers KB0, KB1, KB2 and KC0, comparator and programmable
gain amplifier , 32MHz or 16MHz is supplied to CPU and other peripheral function.
R20UT0766EJ0200 Rev.2.00
2012.03.30
Table 1-1. QB-RL78I1A Hardware Specifications
Parameter
Main High-speed
system system clock
clock
Internal high-speed
Note1
oscillation clock
Low-speed system clock
Note1
Subsystem clock
Note2
(only 38pin device)
Phase locked loop (PLL)
Note3
Target system power supply
Specification
RL78/I1A
2.7～5.5V
2.7 V  V  5.5 V：1～20 MHz
DD
At using Phase locked loop (PLL) : 32 MHz Max
2.7 V  V  5.5V：1～32 MHz
DD
2.7 V  V  5.5 V：15 kHz
DD
2.7 V  V  5.5 V：32.768 kHz
DD
2.7 V  V  5.5 V：64 MHz
DD
0 to 40°C (No condensation)
−15 to 60°C (No condensation)
See figure below
Voltage: 2.7 to 5.5 V
Current: approx. 250 mA MAX
Approx. 400 g
USB interface (1.1, 2.0)
CHAPTER 1 GENERAL
Page 8 of 38