User Output Commands - Denso RC5 Interface Manual

2.4.5 User Output Commands

There are three types of user output commands, SET, RESET and OUT. The SET
and RESET commands turn ON and OFF all user outputs specified by I/O type
variables. The OUT command outputs data to a specified user output.
The SET command turns ON all user outputs specified by I/O type variables.
For further information about the SET command, refer to the PROGRAMMER'S
MANUAL (I), Chapter 13, Section 13.1 "SET."
The RESET command turns OFF all user outputs specified by I/O type variables.
For further information about the RESET command, refer to the PROGRAMMER'S
MANUAL (I), Chapter 13, Section 13.1 "RESET."
The OUT command outputs data to the user output specified by an I/O type variable.
For further information about the OUT command, refer to the PROGRAMMER'S
MANUAL (I), Chapter 13, Section 13.1 "OUT."
SET Command
RESET Command
OUT Command
25