Advertisement
Scanning Originals Separately Set as One Document (Job
Build)
This mode enables you to scan originals that are too many to set at once, by dividing them into
multiple batches. You can use both the feeder and the platen glass for scanning. The originals are
stored as one document after all the batches have been scanned.
IMPORTANT
• You cannot change the scan settings while scanning originals in the Job Build mode. You need to set the
necessary settings beforehand according to the type of original and desired Finisher mode.
• If you place the original in the feeder, remove the original sequentially from the original output area when
scanning is completed.
• When you place different-size originals in the feeder, set the Different size Originals mode.
NOTE
• When you want to scan one-sided and two-sided originals as two-sided, set the Two-sided Original mode
beforehand if the first batch of originals is two-sided. To scan next original(s), set or cancel the Two-sided
Original mode according to the type of original.
• It is useful to store originals in a box and print them with the Merge Documents mode when you cannot
prepare originals at once, or when you want to set different settings for each original. (See "Printing Multi-
ple Documents as One Document (Merge Documents)," on p. 4-75.)
1
Prepare to scan the original into the box following the procedure below.
Select the desired box number
MAIL BOX
NOTE
• When you select a box set with a password, enter the password after selecting the box.
2
Press the [Special Features] key.
Place the original
Job build
Scanning Originals into a Box
4-45
Advertisement
Chapters
