Advertisement
Making Copies Using the Stack Bypass
When making copies on transparencies or non-standard size paper stock, place the paper stock in
the stack bypass. The following two kinds of paper can be copied using the stack bypass.
Standard Size
You can place standard inch paper, and A or B series paper.
Free Size
You can place non-standard size (4"x5-7/8" to 11"-5/8"x17" (100 mm x 148 mm to 297 mm x 432
mm)) paper.
IMPORTANT
• Note the following points when using the stack bypass.
- Copy quantity: 1 to about 50 sheets (stack about 3/16" (5 mm) high)
- Paper size: 4"x5-7/8" to 11"-5/8"x17" (100 mm x 148 mm to 297 mm x 432 mm)
- Paper weight: 17-lb bond to 110-lb index (64 g/m
- Curl down paper before use.
(Curling amount: less than 3/8" (10 mm.))
There are some types of paper stock which may meet the above specifications but cannot be fed in the
stack bypass.
• Place STMT-size paper horizontally in the stack bypass.
• Do not set different size paper at the same time.
• When you set free-size paper, combined use with the Auto Copy Ratio, Entire Image, Staple, Hole Punch,
1 2-Sided, 2 2-Sided, Book 2-Sided, Two-page Separation, Cover/Sheet Insertion, Shift, Booklet, Trans-
parency Interleaving, Image Combination, Image Separation, and Image Repeat modes cannot be set.
NOTE
• When copying the following originals, you cannot use Automatic Paper Selection. Use Manual Paper
Selection with these types of paper.
- Highly transparent originals such as transparencies
- Originals with an extremely dark background
1
Open the stack bypass.
NOTE
• If the paper you want to specify is already in the
stack bypass, press the [Paper Select] key, then
specify the desired paper.
• If the paper size loaded in the stack bypass is dif-
ferent from the paper size stored in the Standard
Stack Bypass Settings, press the [StackBypass
Setting] key and change the setting to the loaded
paper size. (See "Setting the Standard Paper for
the Stack bypass," on p. 6-19.)
• If the paper loaded in the stack bypass is not the
paper which you want to specify, check whether or
not there is a current job or a reserved job. (
"Checking and Changing Printing Status," on
p. 5-13.
)
- If there is a current/ reserved job, reserve a change
for the stack bypass. (See "Using the Stack Bypass
while Reserving Print Jobs," on p. 5-10.)
2-12
Making Copies Using the Stack Bypass
2
2
to 200 g/m
)
See
Advertisement
Chapters
