Advertisement
Copying Separately-Set Originals
This mode enables you to scan originals that are too many to set at once, by dividing them into mul-
tiple batches. You can use both the feeder and the platen glass for scanning. The originals are cop-
ied as one document after all the batches have been scanned.
Originals
IMPORTANT
• You cannot change the copy settings while scanning originals in the Job Build mode. You need to set the
necessary settings beforehand according to the type of original or the desired Finisher mode.
• If you place the original in the feeder, remove the original sequentially from the original output area when
scanning is completed.
• When you place different-size originals in the feeder, set the Different Size Originals mode.
NOTE
• When you want to copy one-sided and two-sided originals as two-sided, set the 1 2-Sided mode before-
hand if the first batch of originals is one-sided. If the first batch is two-sided, set the 2 2-Sided mode
beforehand. To scan next original(s), set or cancel the Two-sided Original mode according to the type of
original.
• It is useful to store originals in a box and print them with the Merge Documents mode when you cannot
prepare originals at once, or when you want to set different settings for each original. (See "Printing Multi-
ple Documents as One Document (Merge Documents)," on p. 4-75.)
1
Place your first original and press the [Special
Features] key.
(Job Build)
Copies
Job Build
Copying Separately-Set Originals (Job Build)
3-45
Advertisement
Chapters
