Advertisement
Removing Paper Jams in the Saddle Stitcher Unit
If a paper jam occurs when the booklet mode was set
using Saddle Finisher-F2, the screen shown at right
appears. Remove the jammed paper according to
the instructions on the screen.
NOTE
• This procedure is only required when Saddle Fin-
isher-F2 is attached.
CAUTION
• When removing jammed originals or paper, take care not to cut your hands on the edges of the
original or paper.
• When removing jammed paper or when inspecting the inside of the machine, do not allow neck-
laces, bracelets or other metal objects to touch the inside of the machine, as this may result in
burns or electrical shock.
• When removing paper which has become jammed inside the machine, take care not to allow the
toner on the jammed paper to come into contact with your hands or clothing, as this will dirty your
hands or clothing. If they become dirty, wash them immediately with cold water. Washing with
warm water will set the toner and make it impossible to remove the toner stains.
• When removing paper which has become jammed inside the machine, remove the jammed paper
gently to prevent the toner on the paper from scattering and entering your eyes or mouth. If toner
enters your eyes or mouth, wash immediately with cold water and consult a physician.
1
Move the Saddle Finisher-F2 away from the
main unit, holding the section indicated in the
figure on the right.
2
Remove the paper in the stack.
Finisher-F1/ Saddle Finisher-F2/ Puncher Unit-B1
9-21
Advertisement
Chapters
